.JPG) Universal Transponder
Bypass Module for Remote Start Products. |
 The immobilizer interface module is used when installing remote start products in vehicles equipped with an RF(Radio Frequency) based immobilizer system. This type of system uses a small chip in the original iginition key, called a transponder, to transmit a lower powered RF signal. This signal is picked up trough an antenna (or coil) around the ignition switch which is then sent to the immobilizer's transceiver. Once the correct signal is received, the immobilizer will enable the ignition and/or fuel systems. If an attempt is made to start the vehicle and the transceiver does not receive a valid code, the ignition and sometimes the fuel systems are disabled. The immobilizer system will then render the remote start useless. HT-SB01 bypass the immobilizer system only while the remote start is in use, maintaining the factory system's integrity. When the remote start system is not in use the factory immobillzer remains fully functional. |
|
 - The immobilizer bypass module is used when installing remote start products in vehicles equipped with an RF based immobilizer system. - Works on all factory anti-theft system (791, Passlock, Passlock II, Passkey, etc...). - You will also need an additional key to put inside the bypass module if your vehicle original key is chipped (Transponder type). |
||
/25.gif) |
|
|